Hi All,
We are trying to monitor & control multiple networks. done configuring cisco core as trunk port allowing particular vlans.
on genian side, done configuring as trunk port with sample IP below
# configure terminal
# interface eth0.1 address 10.1.1.5 255.255.255.0
# interface eth0.1 gateway 10.1.1.1
# interface eth0.1 vlan 1,10,15
# interface eth0.1 management-server enable
# interface eth0.1 node-server enable
# interface eth0.1 radius-server enable
# exit
But the problem is, after configuration, we can’t access nor ping the ip 10.1.1.5. please help.
Regards,
Olais
In my Case
192.168.55.0 network native VLAN. – Untagged VLAN
192.168.60.0 network VLAN 60.- Tagged VLAN
You must distinguish between tagged VLAN and Untaged VLAN.
eth0.X interface. It is an interface that supports tagged VLAN.
eth0 interface supports untagged VLAN. (native VLAN)
Switch
interface FastEthernet1/0/8
switchport trunk enapsulation dot1q
switchport mode trunk
switchport trunk native vlan 1
——————————————————————-
GeniansNAC
interface eth0.60 address 192.168.60.20 255.255.255.0
interface eth0.60 gateway 192.168.60.1
interface eth0 address 192.168.55.20 255.255.255.0
interface eth0 gateway 192.168.55.254
interface eth0 management-server enable
interface eth0 node-server enable
interface eth0 radius-server enable
interface eth0 vlan 60
interface wlan0 mode monitor
ip default-gateway 192.168.55.254